2017 Jeep Wrangler Lug Nut Torque Guide

2017 Jeep Wrangler Lug Nut Torque Specifications

Why Lug Nut Torque Matters

Properly torquing the lug nuts on your 2017 Jeep Wrangler is crucial for the safety and performance of your vehicle. The correct torque ensures that the wheels are securely fastened to the vehicle, preventing them from coming loose while driving. It also helps distribute the load evenly across the wheel studs, reducing the risk of stud failure or wheel damage. In this article, we will provide you with the recommended lug nut torque specifications for your 2017 Jeep Wrangler.

Recommended Torque Specifications

To ensure the correct torque is applied to your Jeep Wrangler’s lug nuts, it is important to follow the manufacturer’s recommendations. The table below provides the lug nut torque specifications in both lb-ft (pound-feet) and Nm (Newton-meters):

Wheel Size Lug Nut Torque (lb-ft) Lug Nut Torque (Nm)
15-inch 85-95 115-130
16-inch 85-95 115-130
17-inch 85-95 115-130
18-inch 85-95 115-130
20-inch 85-95 115-130

How to Properly Torque Lug Nuts

To ensure the lug nuts are torqued correctly, follow these steps:

  1. Start by securing your vehicle on a level surface and engaging the parking brake.
  2. Using a lug wrench or a torque wrench, loosen the lug nuts on the wheel you intend to work on. Loosen them in a crisscross pattern to prevent the wheel from tilting.
  3. Once the lug nuts are loose, use a jack to lift the vehicle off the ground, ensuring it is stable and secure.
  4. Completely remove the lug nuts and carefully take off the wheel.
  5. Clean the wheel studs and the mounting surface to remove any debris or rust.
  6. Place the wheel back onto the mounting surface, aligning the holes with the wheel studs.
  7. Hand-tighten the lug nuts in a crisscross pattern to ensure the wheel is centered.
  8. Using a torque wrench, tighten the lug nuts to the recommended torque specification for your specific wheel size (refer to the table above).
  9. Repeat the process for each wheel, ensuring all lug nuts are torqued properly.
  10. After torquing all the lug nuts, lower the vehicle back to the ground and remove the jack.
  11. Finally, double-check the lug nuts to ensure they are tightened to the correct torque specification.

Regular Maintenance

It is important to periodically check the lug nut torque on your Jeep Wrangler to ensure they remain properly tightened. This is especially crucial after any tire rotations, wheel replacements, or off-road adventures. Additionally, if you notice any unusual vibrations or noises coming from your wheels, it is recommended to check the lug nut torque as a precautionary measure.

Conclusion

Properly torquing the lug nuts on your 2017 Jeep Wrangler is essential for your safety and the longevity of your vehicle. By following the recommended torque specifications and using the correct torquing procedure, you can ensure that your wheels are securely fastened and ready to take on any adventure. Remember to periodically check the lug nut torque as part of your regular maintenance routine. Stay safe on the road and enjoy your Jeep Wrangler to the fullest!

Leave a Reply