Mitsubishi Canter Wheel Nut Torque Setting
What is Wheel Nut Torque Setting?
Wheel nut torque setting refers to the specific amount of torque or rotational force that should be applied to tighten the wheel nuts on a vehicle’s wheels. This is crucial to ensure the proper installation and secure fitment of the wheels, which is essential for safe driving.
Importance of Correct Wheel Nut Torque Setting
Using the correct wheel nut torque setting is vital for several reasons:
1. Safety: Properly tightened wheel nuts prevent the wheels from coming loose while driving, reducing the risk of accidents or wheel detachment.
2. Wheel Alignment: Incorrect torque settings can lead to uneven pressure distribution on the wheel, affecting the vehicle’s alignment and causing premature tire wear.
3. Wheel Studs and Threads: Over-tightening or under-tightening the wheel nuts can damage the wheel studs or threads, leading to costly repairs.
Mitsubishi Canter Wheel Nut Torque Setting Chart
Here is a detailed chart providing the recommended wheel nut torque settings for various Mitsubishi Canter models:
| Model | Year | Torque Setting (lb-ft) | Torque Setting (Nm) |
|---|---|---|---|
| Mitsubishi Canter FE125 | 2005-2010 | 80-90 | 108-122 |
| Mitsubishi Canter FE160 | 2005-2010 | 90-100 | 122-136 |
| Mitsubishi Canter FE180 | 2005-2010 | 100-110 | 136-149 |
| Mitsubishi Canter FE125 | 2011-present | 90-100 | 122-136 |
| Mitsubishi Canter FE160 | 2011-present | 100-110 | 136-149 |
| Mitsubishi Canter FE180 | 2011-present | 110-120 | 149-163 |
Steps to Properly Torque Wheel Nuts
To ensure the correct wheel nut torque setting, follow these steps:
- Use a torque wrench: Invest in a reliable torque wrench to accurately measure the torque applied to the wheel nuts.
- Clean the wheel studs and nuts: Remove any dirt, debris, or rust from the wheel studs and nuts to ensure a proper fit.
- Hand-tighten the nuts: Start by hand-tightening the wheel nuts in a crisscross pattern to ensure even pressure.
- Use the torque wrench: Set the torque wrench to the recommended torque setting according to the chart provided.
- Tighten the nuts: Begin tightening the wheel nuts in the same crisscross pattern, gradually increasing the torque until the desired setting is reached.
- Double-check the torque: After tightening all the nuts, go over them again to ensure they are properly torqued.
Final Thoughts
Properly torquing the wheel nuts on your Mitsubishi Canter is essential for safety and maintaining the longevity of your vehicle. Always refer to the manufacturer’s recommended torque settings and follow the steps outlined above to ensure a secure and reliable fitment of your wheels. Remember, using a torque wrench and following the correct torque settings is crucial for a safe and enjoyable driving experience.